CloseHomeApplicationsComparisonNewsContact

Article Notes

During lamination, EVA film passes through three stages. It softens under heat, flows around the cell string and interconnect ribs, and finally crosslinks into an insoluble network. Each stage has to happen in order: if the film gels before it has wetted the cells, air stays trapped at the cell edges.

Adhesion develops at both faces of the film. On the glass side the bond is optical and structural; on the cell side it locks the string in place and insulates the circuit. Holding the press at about 140–150 °C until gel content reaches at least 75% is the usual way to verify the cure has completed.

Related application

Key Points

  • Control the Heat Rate

    A steady ramp gives the film time to flow before crosslinking begins.

  • Watch the Edges

    Most voids start where film meets interconnect ribs; inspect this area first.

  • Verify the Cure

    Gel content and optical clarity together indicate a sound laminate.

Further Reading

This article belongs to the Technical line for Solar Cell Encapsulation. The application page brings together processing guidance, application scenarios and packaging detail for this use of EVA film.

You can also read the other two lines in the same series from the news center, or compare all four applications on the comparison page.

Related Applications

Open an application page for full detail.

Start a Conversation

Scan to chat with Julie Gong on WhatsApp.