CloseHomeApplicationsComparisonNewsContact

Article Notes

Voids in a laminate usually begin as air trapped at cell corners or along interconnect ribs. If the film becomes too stiff before that air has escaped, the pocket is sealed into the finished panel and scatters light at the cell surface.

Prevention is a combination of clean lay-up, adequate vacuum and a film that stays flowable long enough. Operators can also look at the heat-up rate: a gentler ramp gives trapped air more time to leave before crosslinking fixes the structure.

Related application

Key Points

  • Start Clean

    Dust and moisture on the film surface can seed small voids.

  • Allow Flow Time

    Do not shorten the hot stage so much that air cannot escape.

  • Inspect Corners

    Cell corners are the first place to check on a sample laminate.

Further Reading

This article belongs to the Knowledge line for Solar Panel Lamination. The application page brings together processing guidance, application scenarios and packaging detail for this use of EVA film.

You can also read the other two lines in the same series from the news center, or compare all four applications on the comparison page.

Related Applications

Open an application page for full detail.

Start a Conversation

Scan to chat with Julie Gong on WhatsApp.