CloseHomeApplicationsComparisonNewsContact

Article Notes

A lamination cycle heats the film until it flows, then holds it long enough for the crosslinking reaction to build a network. Before that reaction completes, the film can still move; after it completes, the laminate is a single solid piece that will not melt again in service.

Vacuum removes air before the film gels, and pressure keeps the layers in contact. The balance between flow time and gel time is what operators manage when they set temperature and dwell for a given panel format.

Related application

Key Points

  • Sequence Matters

    Flow and wet-out must happen before the film reaches its gel point.

  • Hold Pressure

    Pressure keeps glass, cells and backsheet in contact during the cure.

  • Check the Cure

    Gel content at or above 75% indicates the network has formed.

Further Reading

This article belongs to the Technical line for Solar Panel Lamination. The application page brings together processing guidance, application scenarios and packaging detail for this use of EVA film.

You can also read the other two lines in the same series from the news center, or compare all four applications on the comparison page.

Related Applications

Open an application page for full detail.

Start a Conversation

Scan to chat with Julie Gong on WhatsApp.