CloseHomeApplicationsComparisonNewsContact

Article Notes

Roll film suits long runs of one module size, where automated cutting recovers the setup cost. Sheet film suits short runs, prototypes and lines that change format often, because the cutting work has already been done.

The encapsulant itself behaves the same in the laminator. The choice is therefore about the lay-up station: how often the format changes, how much offcuts matter and how much space is available for storing film.

Related application

Key Points

  • Long Runs

    Roll feeding is efficient when one size stays on the line.

  • Mixed Sizes

    Sheets reduce changeover work across several module formats.

  • Same Cure

    Both formats reach the same gel and transmission targets in the press.

Further Reading

This article belongs to the Knowledge line for EVA Film Sheet. The application page brings together processing guidance, application scenarios and packaging detail for this use of EVA film.

You can also read the other two lines in the same series from the news center, or compare all four applications on the comparison page.

Related Applications

Open an application page for full detail.

Start a Conversation

Scan to chat with Julie Gong on WhatsApp.